Excalibur AL-1950-EDPB Installation Manual download pdf (Page 11)

Using The V

alet Switch (cont’d)

REMOTE ST

ART V

ALET

MODE, while active, disables remote start. Keyless entry

and alarm functions are still operable.

o enter remote start valet mode, perform the

following steps:

STEP 1 - Disarm the system either with the controller or by performing an emergency

override and hold the brake pedal

STEP

2 -

Press and hold the valet switch (located in the window-mount antenna) for

2 seconds

The system will chirp once and the

GREEN status light will turn on.

The

controller will not reect remote start valet mode.

FULL

ALET

MODE combines both alarm & remote start valet modes.

o acti-

vated full valet mode, follow these steps:

STEP 1 - Enter remote start valet

ou will hear a chirp

STEP

2 -

Release the brake pedal but continue holding the valet switch

After 2 sec-

onds, you will hear a second chirp

STEP

3 -

Immediately release the valet switch

The status light will alternate between

RED and

GREEN every second.

EXITING V

ALET

MODES is as simple as just pressing and releasing the valet

switch once.

The status light will turn of

This procedure is the same for all forms of

valet mode

SECURECODE

SecureCode allows you to customize the number of valet presses required to per-

form an emergency override.

This is an extra layer of security that prevents anyone

from overriding the alarm even if they have a key to the vehicle

. SecureCode has 2

stages with the rst requiring 1-9 button valet presses and the second requiring 0-9

valet button presses.

This gives you 99 possible combinations

o program a custom

SecureCode, please refer to user feature #1

o perform an emergency override with

SecureCode, use the following steps:

STEP 1 - With the system armed, enter the vehicle (the alarm will trigger)

STEP

2 -

Turn the ignition switch to the “ON” position

STEP

3 -

Within 5 seconds of step 2, press the valet switch to enter the rst digit of

your programmed code

STEP

4 -

After a few seconds, the siren will stop sounding and chirp once (conrming

stage 1)

The siren will then continue sounding

STEP

5 -

Now, within 5 seconds of step 4, press the valet switch to enter the second

digit of your code

. If the code is correct, the alarm will disarm.

If the code is entered incorrectly

, you must turn the ignition key OFF

, then back

ON to try again

. Additionally

, if 2 failed attempts are made, the alarm will ignore any

further attempts for 2 minutes

The Status Light

The status lights, located in the window-mount antenna, provide a visual indication

of the system’s status via GREEN (remote start status) and RED (alarm status) lights.

SECURITY SYSTEM STA

US (RED LIGHT):

OFF: The alarm is disarmed and not performing any automatic functions.

ON CONSTANT:

The alarm is in valet mode

FLASHING SLOW:

The alarm is armed and monitoring all entry points

FLASHING FAST

: One of the automatic arming features is in progress

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Comments to this Manuals

No comments

Excalibur AL-1950-EDPB Installation Manual Page 11

Comments to this Manuals

Related products and manuals for Remote starters Excalibur AL-1950-EDPB