Controller & T
ransmitter Overview (cont’d)
“lock”
button
“trunk”
button
“unlock”
button
“start”
button
AL-1950-EDPB part number: 148-03
AL-2050-EDPB part number: 1410-03
Call your dealer or visit www.caralarm.com to
order replacement transmitters.
T
ransmitter battery replacement:
Remove the small screw from the lower
back case, and separate the transmitter
halves
. Replace the battery(ies) and reas-
semble the transmitter case.
Battery Types:
148-03 - CR2016 (2 required)
1410-03 - CR3032 (1 required)
THE 1-WAY TRANSMITTER
Controller & T
ransmitter Functions
LOCK / ARM: Press and release the “LOCK” button.
THE SIREN WILL CHIRP & THE PARKING LIGHTS WILL •
FLASH ONCE.
UPON RECEIVING CONFIRMATION FROM
YOUR •
SYSTEM, THE CONTROLLER WILL PLA
Y
THE LOCK/ARM
ANIMATION AND BEEP ONCE
NOTE: PRESSING LOCK TWICE IN 5 SECONDS STARTS
THE PARKING TIMER. THE CLOCK WILL CHANGE TO
0:00 AND START COUNTING IN MINUTES & HOURS.
(1-WA
Y TRANSMITTER: PRESS THE LO
CK BUTTON)
UNLOCK / DISARM: Press and release the “UNLOCK” button.
THE SIREN WILL CHIRP TWICE & THE PARKING •
LIGHTS WILL FLASH TWICE THEN ILLUMINATE FOR 30
SECONDS.
UPON RECEIVING CONFIRMATION FROM
YOUR •
SYSTEM, THE CONTROLLER WILL PLA
Y
THE UNLOCK/
DISARM ANIMATION AND BEEP TWICE.
(1-WA
Y TRANSMITTER: PRESS THE
UNLOCK BUTTON)
NOTE: The 2-way Controller is shipped from the factory in POWER OFF mode.
If you connect the charger before powering it, perform POWER OFF, then
POWER ON again.
POWER ON: Press and hold the “P” button for at least 1 second
POWER OFF: Press the “P” and “ “ buttons for at least 1 second
*
1410-03 Pictured
Comments to this Manuals